Paragon Windows of Oxfordshire

Tel: (01993) 868791

Product Care and Maintenance



The advice and guidance hereunder is provided to enable you to obtain the best service and appearance from your product.



General Cleansing of PVCu and Glass



These products are best cleaned by regular washing with warm water. A small amount of washing up liquid can be added as necessary to help remove more stubborn dirt and greasy marks. Internal surfaces of white PVCu may suffer discolouration if exposed to continuous cigarette smoke or cooking fumes. In such circumstances you should consult with your installer. Under no circumstances should you employ any chemical cleaning agents or abrasive substances to restore the original colour as it may harm either the product or glazing gaskets.



Residential Doors



After washing as instructed, ensure that all accumulated dirt and deposits are flushed out from the various drainage slots situated in the cill of the outer frame. Spare keys for standard locks will be obtainable from your local locksmith or iron-monger in the normal way. For enhanced Mul-T-Lock mechanisms, spare keys can only be obtained from specialist suppliers and will require the accompanying plastic key card. Paragon Windows can advise of such local specialists upon request.



Lubrication of the lock should be achieved with a graphite-based lubricant designed for the purpose. This is particularly important where the lock mechanism is exposed to attack from either salt or other chemicals in the local atmosphere.



Hinges should also be inspected and lubricated from time to time. Make sure to wipe off excess lubricant in all instances.



Patio Doors



Ensure if possible that your patio door is not slammed shut with the locking lever in the ‘up’ or locked position, as this may damage the lock, lock keep or the jamb itself. Such abuse may eventually warrant either lock repair or adjustment. Similarly endeavour not to slam the door open as this may result in subsequent damage to the door-stop.



Particular care should be taken to regularly inspect the door track and to remove dirt, stones or other debris. This area should thereafter be cleaned with warm water and a soft brush. Locks, locking points and levers should all be regularly treated with a graphite-based lubricant.



Casement Window



Should the operation of the opening vents appear ‘slack’ the situation can be remedied by simply adjusting the pressure of the friction stays. To achieve this, arrange the vent in the fully open position and locate the small brass screws housed in the side of the stays fixed to the main window frame. Be careful not to over-tighten the screws and a maximum of one quarter turn should be sufficient on each occasion. Important - both stays should be adjusted to the same extent in order to maintain the equalised tension.



Whilst the surface of the stays may be lightly sprayed with silicone for protection in saline atmosphere, a light machine oil can be applied to the pivotal points, one drop per pivot.



Where espagnolette & shoot-bolt locking is fitted, the system should be regularly and lightly lubricated, especially if exposed to salty air or damp conditions such as a bathroom or kitchen area.



Locking Handles



Under no circumstances should the handle be forced into the open position without the key release. For the benefit and convenience of the home owner, it is strongly recommended that if the key is removed from the handle, it is located within easy reach in order to facilitate any need for emergency opening.



General Notes on Ventilation & Condensation



a) Once your property has been converted to double glazed products, draughts should be a thing of the past. It will, however be necessary for you to decide how you will allow ventilation to enter your property, albeit on a controlled basis. This is particularly important if you employ either gas or paraffin heaters on the premises, where there could be a build up of noxious fumes. Be sure to mention this to your Installer and he will advise the best method of alleviating any problems in this respect as well as limiting resultant condensation.



b) Unfortunately, condensation is a fact of life. Wherever there is moisture present in the atmosphere, and substantially differing temperatures on either side of any surface, degrees of condensation will occur. The effect is directly proportional not only to the temperature variation, but also to the amount of water vapour present. When you consider that the average adult will exhale around one pint of water during the night, and that windows invariably offer the coldest surface within a room (certainly if facing the worst of the weather), it is not surprising that bedrooms in particular, but also kitchens, lounges and bathrooms are most likely to suffer from this problem especially if not well ventilated.